C2-260/inBio2-260 Access Control Panel
User Manual
Page | 26 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
4. Click Add in the search list.
If the device is a pull device, you may enter a device name and click OK to complete adding the device.
Clear Data in the device when Adding: If this option is selected, after adding a device, the system will
clear all data in the device (except the event logs).
If the device is a push firmware device, the following windows will pop-up after clicking Add. If the IP
Address in New Server Address is selected, then configure the IP address and port number. If Domain
Address in New Server Address option is selected, then set the Domain address, port number, and DNS.
The device will be added to the software automatically.
To Next Page
Loading...
Need help?
General
