C2-260/inBio2-260 Access Control Panel
User Manual
Page | 27 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
New Server Address: To add a device by IP Address or Domain Address, devices can be added to the
software by entering the domain address.
New Server Port: Set the access point of the system.
DNS: Set a DNS address of the server.
Clear Data in the Device when Adding: If this option is selected, then after adding a device, the system
will clear all data in the device (except the event logs). If you add the device merely for demonstration or
testing, there is no need to select it.
Note: When using either of the above three device adding methods, if there exists a residual data in the
original device, please sync the original data to it after adding a new device to the software by clicking
Device > Synchronize All Data to Devices, otherwise, these original data may conflict with normal
usage.
To Next Page
Loading...
Need help?
General
