C2-260/inBio2-260 Access Control Panel
User Manual
Page | 29 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
Select the device and click OK. Select the I/O Board Type. Set the RS485 Code Address by changing the
corresponding button. Click OK to save the details. You can view all the auxiliary inputs in the Auxiliary
Input interface.
Note: Please select this method when adding DM10 and AUX485.
5.4.3 Device Operation
For the communication between the system and device, data uploading, configuration downloading,
device, and system parameters shall be set. Users can edit the access controllers within the appropriate
levels in the current system; users can only add or delete devices in Device Management if needed.
To Next Page
Loading...
Need help?
General
