C2-260/inBio2-260 Access Control Panel
User Manual
Page | 43 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
Different icons represent the status as follows:
1. Door
Remote Opening/Closing: It can control one door or all the doors.
To control a single door, right-click on it, and click Remote Opening/ Closing in the pop-up window. To
manage all entries, directly click Remote Opening/ Closing in Current All option.
In the remote opening, the user can define the door opening duration (The default is 15s). You can select
[Enable Intraday Passage Mode Time Zone] to enable the intraday door passage mode time zones or
set the door to Normal Open, and then the door will not be limited to any time zones (can be opened at
any time).
To close a door, select [Disable Intraday Passage Mode Time Zone] first, to avoid enabling other normal
open time zones to open the door, and then select [Remote Closing].
Note:
If [
Remote Opening /Closing
] fails, check whether the devices are disconnected or not. If
disconnected, check the network connectivity.
Cancel the alarm
: Once an alarming door pops-up over the interface, the alarm sound will be played.
Alarm cancellation can be made for a single door and all the entries. To control a single door, move the
cursor over the door icon, a menu will pop-up, then click
Remote Opening/ Closing
on the menu. To
manage all the doors, directly click
Remote Opening/ Closing
in Current All option.
Note:
If
Cancel the alarm
fails, check if any devices are disconnected. If found disconnected, check the
network.
Remote Normally Open
: It will set the device as normal open by remote.
To Next Page
Loading...
Need help?
General
