906-0731-01-05 Rev. C ZOLL Ventilator Operator’s Guide 3-1
Chapter 3
Setting Up the ZOLL Ventilator
This chapter describes how to set up the ZOLL Ventilator. It lists the tasks required to set up the
ventilator for safe, effective use, and describes each task in detail.
Warning! You must always properly set up the ventilator before use. Failure to do so can result in
inadequate care or death of the patient.
To set up the ZOLL Ventilator, you must perform the following tasks:
1. Attach the Ventilator Circuit
2. Attach the High Pressure Oxygen Supply (Optional)
3. Inspect Fresh Gas Intake Filters
4. Connect Fresh Gas Intake Attachments
5. Select the Ventilator’s Power Source
6. Power on the Ventilator
7. Select Start Up Default Values
8. Select Operating Mode (Optional)
9. Change Parameter Values
10. Change Ventilator Settings
11. Perform Operational Test
12. Attach the Pulse Oximeter Probe (Optional)
13. Attach Patient
We describe how to perform these tasks in the following sections of this chapter.
To Next Page
Loading...
Need help?
General
