ZXHN H3600 Maintenance Management Guide
Parameter Description
Manual: One or more prefixes selected manually from all the
static prefixes configured before will be delegated.
Disabled: No prefix will be delegated.
3. Click Apply button to apply the changes.
Configure the RA Service
1. Click RA Service to the configuration page, see Figure 6-15.
Figure 6-15 RA Service Page
2. Configure the RA service parameters.Table 6-11 lists the RA service parameters.
Table 6-11 Parameter Descriptions for the RA Service
Parameter Description
RA Service Click On to enable the function. Click Off to disable the function.
Specify MTU If On button is selected, enter the MTU value.
MTU Define the maximum transfer unit.
Preference By default, the preference is Middle.
Minimum Retry Interval
The minimum time allowed between sending unsolicited multi-
cast Router Advertisements from the interface. (The value must
not be greater than 0.75 * (Maximum Retry Interval )).
Maximum Retry Interval
maximum time allowed between sending unsolicited multicast
Router Advertisements from the interface.
M
Managed flag.
Select this check box to enable the connected devices to obtain
the IPv6 address through DHCP IPv6.
60 SJ-20201203151144-003 | 2021-06-16(R1.0)
To Next Page
Loading...
