MG Series Gateway Setup Manual ver 306.X (0000000272)
Revision 20 Jul. 12, 11
© 2011 Zultys, Inc. No reproduction of distribution without permission
Page 12 of 42
RJ11 Interface Configuration
6 Basic Settings
Basic settings are where you set the IP addressing and SIP Registrations settings. SIP
registration settings for the FXS/FXO port MUST be set LAST, to prevent the MX
from blocking the IP address of the MG8. If the IP address is blocked by the MX (a
syslog event will be generated) you must restart them MX to remove this block.
To Next Page
Loading...
General