MG Series Gateway Setup Manual ver 306.X (0000000272)
Revision 20 Jul. 12, 11
© 2011 Zultys, Inc. No reproduction of distribution without permission
Page 40 of 42
Password as part of account information is used for authentication
by platform. It has no default value. It is formed with either numbers
or characters, and case sensitive.
the password
Valid time of SIP re-registration in second.
13 Additional Options
To enable additional settings you will need to use Internet Explorer, and enter
custom http urls in the Address window.
13.1 Enable Busy Tone Detection for FXO
To enable Busy Tone Detection for FXO
URl: http://xx.xx.xx.xx/xml?method=gw.config.set&pass=voip&id235=zzz
For US the zzz recommended value is 480 (for use in the US set value to 480
which is the busy tone frequency in US)
To view the current value:
http://xx.xx.xx.xx/xml?method=gw.config.get&pass=voip&id=235
13.2 Battery Denial Timing Disconnect for FXO
The minimal timing of consistent battery denial detected on FXO port to recognize
such condition
URl: http://xx.xx.xx.xx/xml?method=gw.config.set&pass=voip&id205=400
The recommended value is 400 ms
To view the current value:
http://xx.xx.xx.xx/xml?method=gw.config.get&pass=voip&id=205
13.3 Using Authentication for Managed devices
on the MG to guarantee that the FXS ports disconnect properly.
URl: http://xx.xx.xx.xx/xml?method=gw.config.set&pass=voip&id638=yes
Read back the current value:
http://xx.xx.xx.xx/xml?method=gw.config.get&pass=voip&id=638
To Next Page
Loading...
General