MG Series Gateway Setup Manual ver 306.X (0000000272)
Revision 20 Jul. 12, 11
© 2011 Zultys, Inc. No reproduction of distribution without permission
Page 3 of 42
11.1 DIGIT MAP ............................................................................................................ 32
11.2 ROUTING TABLE ..................................................................................................... 33
12 SIP PROTOCOL SETTINGS ...................................................................................... 38
12.1 YOU NEED TO SET UP THREE PARAMETERS ON THE SIP CONFIGURATION PAGE. ................ 38
13 ADDITIONAL OPTIONS .......................................................................................... 40
13.1 ENABLE BUSY TONE DETECTION FOR FXO ................................................................. 40
13.2 BATTERY DENIAL TIMING DISCONNECT FOR FXO ........................................................ 40
13.3 USING AUTHENTICATION FOR MANAGED DEVICES ....................................................... 40
13.4 SILENCE AFTER DISCONNECT (FXS PORTS) ................................................................. 41
14 FAIL OVER ............................................................................................................. 41
14.1 SIP FAILURE BETWEEN THE MG AND THE MX ............................................................. 41
14.2 POWER FAIL MG8SO (4FXO/4FXS) ........................................................................ 41
15 TROUBLESHOOTING .............................................................................................. 42
15.1 OUTGOING ON CALLS ON FXO FAIL TO CONNECT. ....................................................... 42
15.2 BLANK SIP MESSAGES ARE BEING SENT TO THE MX FROM THE MG ............................... 42
15.3 MWI LIGHTS ARE NOT SET CORRECTLY ...................................................................... 42
15.4 DNS INFORMATION IS INCORRECT AFTER UPDATING A DNS SERVER .............................. 42
15.5 LOCAL 3 WAY CONFERENCING OF THE FXS PORT ON THE MG DOES NOT WORK BY DEFAULT
42
2 Configure all ports on the MG
You MUST configure all ports on the MG, if you fail to configure all ports (even if
you are not using them) the MG will continue to attempt to register, this action
devices to block the IP of the MG itself.
3 MX250/30 Setup
It is recommended that the MX have a generic SIP device created for each FXS Port
that is on the MG to register against. The Device ID used in the MX will be the
phone number used on the MG for registration purposes; this configuration does
not count against any licensing, as the MX is not licensed by registration.
3.1 Create Users
Create a user for each FXS (SLT) port of the MG gateway by logging into the MX
Admin UI and navigating to Configure | Users.
To Next Page
Loading...
General