MG Series Gateway Setup Manual ver 306.X (0000000272)
Revision 20 Jul. 12, 11
© 2011 Zultys, Inc. No reproduction of distribution without permission
Page 33 of 42
11.2 Routing Table
Recommended settings: (where 192.168.1.1 is the IP Address of the MX)
FXS *38 ROUTE IP 127.0.0.1:5060
IP xxxx ROUTE FXS 1-4/g
IP 192.168.1.1:5060 ROUTE FXS
IP xxxxxx. ROUTE FXO 1-4/R
IP 911 ROUTE FXO 4-1/R
FXO x. ROUTE IP 192.168.1.1:5060
The above settings will allow
1. Blind transfer by doing a hook flash on the FXS and dialing *38 , wait for the
tone and then dial the transfer number
2. In a fail over situation (no IP connection to the MX) calls from the FXO lines
will ring all 4 FXS ports simultaneously
3. Calls from the MX to the FXS ports on the MG8
4. Calls from the MX to the MG8 that are 6 digits and longer are to be routed
to the PSTN (FXO) starting from port 1 to port 4 in a Round Robin manner.
5. Calls from the MX to the MG8 that are the exact match to 911 are to be
routed to the PSTN (FXO) starting from port 4 to port 1 in a Round Robin
manner.
6. Calls from the FXO ports to be sent to the MX
Calls from the FXS to the MX are handled by the registration/proxy process.
To Next Page
Loading...
General