MG Series Gateway Setup Manual ver 306.X (0000000272)
Revision 20 Jul. 12, 11
© 2011 Zultys, Inc. No reproduction of distribution without permission
Page 19 of 42
7 FXS Settings
Use the generic SIP devices you created earlier.
7.1 Setup the Prefix
Enter in the starting number and click Batch, the system will automatically
increment for all available ports.
Those IDs correspond to Generic devices created in MX
You set up the prefix for all the FXS lines on the Phone Number page.
This number is used for the batch setup of consecutive number of
number of Line 1 adopts initial number; that of Line 2 increases 1
if you do not use batch configuration or the number is not
consecutive.
Fill in the generic SIP device ID associated with the subscriber line n
(FXS port). This should be manually performed if Batch mode is not
used.
To Next Page
Loading...
General