MG Series Gateway Setup Manual ver 306.X (0000000272)
Revision 20 Jul. 12, 11
© 2011 Zultys, Inc. No reproduction of distribution without permission
Page 26 of 42
Set the trigger for polarity reversal
Outgoing: Transmit reverse polarity signal only when the
outbound is connected;
Bi-direction: Transmit reverse polarity signal for the
connection of both inbound and out bound calls.
The delay time from call being answered to the transmission of
reverse polarity signal. The default value is 3 in seconds. Effective
range of setting is 0 ~ 30 seconds.
Select transmission mode of Caller ID signal from the FXS port to
the phone.
FSK or DTMF;
SDMF or MDMF;
Sending Caller ID data before or after ringing;
Sending Caller ID data with or without parity.
Choose whether to play the background music while call waiting,
and the default is not to play.
Call waiting with
hunt group
Choose whether to activate hunt group feature for call waiting,
Default not selected.
Choose the lighting method of message waiting indicator of voice
mail here: None, Polarity reversed, FSK. Message waiting indicator
refers to the special LED on a phone, working with voice mail
function. When user gets the latest mail, the gateway will light this
lamp upon receiving the notice from platform; the light goes off
when the user well received all the
understand whether the phone supports the indicators and
lighting method when selecting the lighting method.
9 Create SIP Trunk from Zultys to MG
This SIP Trunk to the MG8 is used to allow calls from the MG8 to the MX and will
be used to place FXO calls out of the MG8.
9.1 Create SIP Trunk on MX
To Next Page
Loading...
General