Chapter 1 Introduction
WAP6806 User’s Guide
11
The following table describes the LED status.
The following table describes the LED combination status of 2.4G and 5G for dual uplink in repeater
mode.
Table 1 WAP6806 LED Status
FUNCTION STATUS DESCRIPTION
Power On (Green) The WAP6806 is receiving power and functioning properly.
Blinking
(Green)
The WAP6806 is booting.
Off The WAP6806 is not receiving power.
Connection
Status
The device uses the LED to generate the following three signal colors:
• Red: signifies a signal strength under 50%
• Orange: signifies a signal strength under 75%
• Green: signifies a signal strength over 75%
System Blinking
(Red)
The WAP6806 has an error.
Blinking
(all colors)
The WAP6806 is resetting to the factory default or upgrading the firmware.
WPS Blinking
(Amber)
The WAP6806’s WPS function is in progress.
Table 2 LED Combination Status of 2.4G and 5G
COMBINATION BAND
EXCELLENT
(100% ~ 70%)
GOOD
(69% ~ 51%)
POOR
(50% ~ 0%)
RESULT
1 2.4G Green Green
5G Green
2 2.4G Green Green
5G Amber
3 2.4G Amber Green
5G Green
42.4GGreen Amber
5G Red
52.4G Amber Amber
5G Amber
62.4G Amber Amber
5G Red
72.4G RedAmber
5G Amber
82.4G RedAmber
5G Green
92.4G RedRed
5G Red
To Next Page
Loading...
