Chapter 3 Repeater Mode
WAP6806 User’s Guide
20
3.5 WPS Screen
Use this screen to connect to another AP. Go to Configuration > Network > Wireless LAN
(2.4G/5G) > WPS to open the following screen.
Note: Wireless clients cannot use WPS to set up a wireless network with the WAP6806 in
repeater mode.
IP Alias This shows the IP address of the WAP6806.
Subnet Mask This shows the subnet mask of the WAP6806.
AP Connection Status - 2.4G / 5G
MAC Address This shows the wireless adapter MAC Address of the root AP.
SSID This shows a descriptive name used to identify the root AP in the wireless LAN.
Channel This shows the channel number which you select manually or the root AP automatically
scans and selects.
Security This shows the level of wireless security the root AP is using.
Status This shows the current status of the Wireless LAN.
Wireless Network Information - 2.4G / 5G
MAC Address This shows the wireless adapter MAC Address of your WAP6806.
Wireless Network This shows whether the wireless LAN function is enabled or disabled.
SSID This shows a descriptive name used to identify the WAP6806 in the wireless LAN.
Link Rate This shows the data transfer rate of the wireless network.
Current Channel This shows the channel number which you select manually or the WAP6806 automatically
scans and selects.
Authentication This shows the wireless security mode used to protect the information that is sent in the
wireless network.
Mode This shows which IEEE 802.1b/g/n wireless networking standards the wireless device
supports.
WPS Status This shows the current status of the WPS.
Table 4 Status Screen: Repeater Mode (continued)
LABEL DESCRIPTION
To Next Page
Loading...
