Chapter 9 Monitor
WAP6806 User’s Guide
50
The following table describes the labels in this screen.
9.4 Statistics
Click Monitor > Statistics. Read-only information here includes port status, packet specific
statistics and the "system up time". The Poll Interval(s) field is configurable and is used for
refreshing the screen.
Figure 36 Monitor > Statistics
The following table describes the labels in this screen.
Table 15 Monitor > Log
LABEL DESCRIPTION
Refresh Click Refresh to renew the log screen.
Clear Log Click Clear Log to delete all the logs.
Table 16 Monitor > Statistics
LABEL DESCRIPTION
Port This is the WAP6806’s port type.
TxPkts This is the number of transmitted packets on this port.
RxPkts This is the number of received packets on this port.
Tx Bytes This displays the transmission speed in bytes per second on this port.
Rx Bytes This displays the reception speed in bytes per second on this port.
Tx Drop This displays the amount of packets that are dropped on the transmitting direction.
Rx Drop This displays the amount of packets that are dropped on the receiving direction.
Tx Error This displays the amount of packets that have errors on the transmitting direction.
Rx Error This displays the amount of packets that have errors on the receiving direction.
System Up Time This is the total time the WAP6806 has been on.
Poll Interval(s) Enter the time interval in seconds for refreshing statistics in this field.
Set Interval Click this button to apply the new poll interval you entered in the Poll Interval(s)
field.
Stop Click Stop to stop refreshing statistics.
Refresh Click Refresh to renew the statistics screen.
To Next Page
Loading...
