Chapter 1 Introduction
WAP6806 User’s Guide
14
1 Locate a high position on a wall that is free os obstructions. Use a sturdy wall.
2 For a concrete or brick wall find a drill bit with the same diameter as the screw anchors. If you do
not need the screw anchors, find a drill bit slightly smaller in diameter than the included screws.
3 Drill two screw holes in the wall. Make sure the distance between the centers of the holes is the
same as the wall-mount holes.
Note: Be careful to avoid damaging pipes or cables located inside the wall when drilling
holes for the screws.
4 Align the holes on the back of the WAP6806 with the screws on the wall. Hang the WAP6806 on the
screws.
To Next Page
Loading...
