Chapter 9 Interfaces
ZyWALL ATP Series User’s Guide
212
Figure 166 Configuration > Network > Interface > Ethernet
Each field is described in the following table.
Table 90 Configuration > Network > Interface > Ethernet
LABEL DESCRIPTION
Configuration / IPv6
Configuration
Use the Configuration section for IPv4 network settings. Use the IPv6 Configuration section
for IPv6 network settings if you connect your Zyxel Device to an IPv6 network. Both sections
have similar fields as described below.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Remove To remove a virtual interface, select it and click Remove. The Zyxel Device confirms you
want to remove it before doing so.
Activate To turn on an interface, select it and click Activate.
Inactivate To turn off an interface, select it and click Inactivate.
Create Virtual
Interface
To open the screen where you can create a virtual Ethernet interface, select an Ethernet
interface and click Create Virtual Interface.
References Select an entry and click References to open a screen that shows which settings use the
entry. See Section 9.3.4 on page 230 for an example.
# This field is a sequential value, and it is not associated with any interface.
Status This icon is lit when the entry is active and dimmed when the entry is inactive.
Name This field displays the name of the interface.
To Next Page
Loading...
