ZyXEL Communications ATP800 - Customizing the WWW Login Page

Chapter 37 System
ZyWALL ATP Series User’s Guide
711
Figure 469 Configuration > System > Service Control Rule > Edit
The following table describes the labels in this screen.
37.7.6 Customizing the WWW Login Page
Click Configuration > System > WWW > Login Page to open the Login Page screen. Use this screen to
customize the Web Configurator login screen. You can also customize the page that displays after an
access user logs into the Web Configurator to access network services like the Internet.
Table 312 Configuration > System > Service Control Rule > Edit
LABEL DESCRIPTION
Create new
Object
Use this to configure any new settings objects that you need to use in this screen.
Address Object Select ALL to allow or deny any computer to communicate with the Zyxel Device using this
service.
Select a predefined address object to just allow or deny the computer with the IP address that
you specified to access the Zyxel Device using this service.
Zone Select ALL to allow or prevent any Zyxel Device zones from being accessed using this service.
Select a predefined Zyxel Device zone on which a incoming service is allowed or denied.
Action Select Accept to allow the user to access the Zyxel Device from the specified computers.
Select Deny to block the user’s access to the Zyxel Device from the specified computers.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving