Chapter 10 Routing
ZyWALL ATP Series User’s Guide
323
10.8.3 The BGP Neighbors Screen
Use this screen to configure BGP information about a peer BGP router.
Click Configuration > Network > Routing > BGP > Add Neighbors to open the following screen.
Figure 221 Configuration > Network > Routing > BGP > Add Neighbors
The following table describes the labels in this screen.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to
remove it before doing so.
# This field is a sequential value, and it is not associated with a specific area.
Network This displays the IP address and the number of subnet mask bits for the peer BGP route.
Apply Click this button to save your changes to the Zyxel Device.
Reset Click this button to return the screen to its last-saved settings.
Table 131 Configuration > Network > Routing Protocol > BGP (continued)
LABEL DESCRIPTION
Table 132 Configuration > Network > Routing Protocol > BGP
LABEL DESCRIPTION
IP Address Type the IP address of the interface on the peer BGP router.
AS Number Type a number from 1 to 4294967295 in this field. Get the number from your service
provider.
Enable EBGP Multihop Select this to allow the Zyxel Device to attempt BGP connections to external peers on
indirectly connected networks. eBGP neighbors must also perform multihop. Multihop is
not established if the only route to the multihop peer is a default route. This avoids loop
formation.
EBGP Maximum
Hops
Enter a maximum hop count from <1-255>. The default is 255.
To Next Page
Loading...
