ZyXEL Communications ATP800 - Service Control Rules; Snmp

Chapter 37 System
ZyWALL ATP Series User’s Guide
732
37.10.2 Service Control Rules
Click the Add or Edit icon in the Service Control table to add a service control rule.
Figure 499 Configuration > System > FTP > Service Control Rule Add/Edit
The following table describes the labels in this screen.
37.11 SNMP
Simple Network Management Protocol is a protocol used for exchanging management information
between network devices. Your Zyxel Device supports SNMP agent functionality, which allows a
manager station to manage and monitor the Zyxel Device through the network. The Zyxel Device
supports SNMP version one (SNMPv1), version two (SNMPv2c) and version 3 (SNMPv3). The next figure
illustrates an SNMP management operation.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.
Table 318 Configuration > System > FTP (continued)
LABEL DESCRIPTION
Table 319 Configuration > System > FTP > Service Control Rule Add/Edit
LABEL DESCRIPTION
Create new
Object
Use this to configure any new settings objects that you need to use in this screen.
Address Object Select ALL to allow or deny any computer to communicate with the Zyxel Device using FTP.
Select a predefined address object to just allow or deny the computer with the IP address that
you specified to access the Zyxel Device using FTP.
Zone Select ALL to allow or prevent any Zyxel Device zones from being accessed using FTP.
Select a predefined Zyxel Device zone on which a incoming service is allowed or denied.
Action Select Accept to allow the user to access the Zyxel Device from the specified computers.
Select Deny to block the user’s access to the Zyxel Device from the specified computers.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving