ZyXEL Communications ATP800 - Allow BGP Packets to Enter the Zyxel Device; Configuring the BGP Screen

Chapter 10 Routing
ZyWALL ATP Series User’s Guide
321
10.8.1 Allow BGP Packets to Enter the Zyxel Device
You must first allow BGP packets to enter the Zyxel Device from the WAN.
1 Go to Configuration > Object > Service > Service Group
2 Select the Default_Allow_WAN_To_ZyWALL rule and click Edit.
3 Move BGP from Available to Member.
4 Click OK.
Figure 219 Allow BGP to the Zyxel Device
10.8.2 Configuring the BGP Screen
Use this screen to configure BGP information about the Zyxel Device and its peer BGP routers.
Click Configuration > Network > Routing > BGP to open the following screen.