ZyXEL Communications ATP800 - Edit Log on USB Storage Setting

Chapter 38 Log and Report
ZyWALL ATP Series User’s Guide
756
38.3.3 Edit Log on USB Storage Setting
The Edit Log on USB Storage Setting screen controls the detailed settings for saving logs to a connected
USB storage device. Go to the Log Setting Summary screen (see Section 38.3.1 on page 751), and click
the USB storage Edit icon.
Figure 521 Configuration > Log & Report > Log Setting > Edit (USB Storage)
The following table describes the labels in this screen.
Table 336 Configuration > Log & Report > Log Setting > Edit (USB Storage)
LABEL DESCRIPTION
Duplicate logs to
USB storage (if
ready)
Select this to have the Zyxel Device save a copy of its system logs to a connected USB storage
device. Use the Active Log section to specify what kinds of messages to include.
Enable log keep
duration
Select this checkbox to enter a value in the Keep Duration field.
Keep Duration Enter a number of days that the Zyxel Device keeps this log.
Active Log
Selection Use the Selection drop-down list to change the log settings for all of the log categories.
disable all logs (red X) - do not send the remote server logs for any log category.
enable normal logs (green check mark) - send the remote server log messages and alerts for
all log categories.
enable normal logs and debug logs (yellow check mark) - send the remote server log
messages, alerts, and debugging information for all log categories.