ZyXEL Communications ATP800 - Page 623

Chapter 34 Object
ZyWALL ATP Series User’s Guide
623
34.6.2.2 IPv6 Address Add/Edit Screen
The Configuration > Object > Address/GeoIP > Address > Add/Edit (IPv6) screen allows you to create a
new address or edit an existing one. To access this screen, go to the Address screen (see Section 34.6.2
on page 620), and click either the Add icon or an Edit icon in the IPv6 Address Configuration section.
Figure 404 Configuration > Object > Address/GeoIP > Address > Add/Edit (IPv6)
The following table describes the labels in this screen.
Ending IP Address This field is only available if the Address Type is RANGE. This field cannot be blank. Enter the end
of the range of IP address that this address object represents.
Network This field is only available if the Address Type is SUBNET, in which case this field cannot be blank.
Enter the IP address of the network that this address object represents.
Netmask This field is only available if the Address Type is SUBNET, in which case this field cannot be blank.
Enter the subnet mask of the network that this address object represents. Use dotted decimal
format.
Interface If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE GATEWAY as the Address Type,
use this field to select the interface of the network that this address object represents.
Country If you selected Geography as the Address Type, use this field to select a country.
FQDN If you selected FQDN as the Address Type, use this field to enter a fully qualified domain name.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving your changes.
Table 259 Configuration > Object > Address/GeoIP > Address > Add/Edit (IPv4)
LABEL DESCRIPTION
Table 260 Configuration > Object > Address/GeoIP > Address > Add/Edit (IPv6)
LABEL DESCRIPTION
Name Type the name used to refer to the address. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This value is case-
sensitive.
Object Type Select the type of address you want to create.
Note: The Zyxel Device automatically updates address objects that are based on an
interface’s IP address, subnet, or gateway if the interface’s IP address settings
change. For example, if you change 1’s IP address, the Zyxel Device
automatically updates the corresponding interface-based, LAN subnet
address object.
IPv6 Address This field is only available if the Address Type is HOST. This field cannot be blank. Enter the IP
address that this address object represents.
IPv6 Starting
Address
This field is only available if the Address Type is RANGE. This field cannot be blank. Enter the
beginning of the range of IP addresses that this address object represents.
IPv6 Ending
Address
This field is only available if the Address Type is RANGE. This field cannot be blank. Enter the end
of the range of IP address that this address object represents.