Chapter 34 Object
ZyWALL ATP Series User’s Guide
672
The following table describes the labels in this screen.
34.13.1.1 DHCPv6 Request Add/Edit Screen
The Request Add/Edit screen allows you to create a new request object or edit an existing one.
To access this screen, go to the Request screen (see Section 34.13.1 on page 671), and click either the
Add icon or an Edit icon.
Figure 442 Configuration > DHCPv6 > Request > Add
The following table describes the labels in this screen.
Table 290 Configuration > Object > DHCPv6 > Request
LABEL DESCRIPTION
Configuration
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove
it before doing so.
References Select an entry and click References to open a screen that shows which settings use the entry.
# This field is a sequential value, and it is not associated with a specific object.
Name This field displays the name of each request object.
Type This field displays the request type of each request object.
Interface This field displays the interface used for each request object.
Value This field displays the value for each request object.
Table 291 Configuration > DHCPv6 > Request > Add
LABEL DESCRIPTION
Name Type the name for this request object. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This value is case-
sensitive.
Request Type Select the request type for this request object. You can choose from Prefix Delegation, DNS
Server, NTP Server, or SIP Server.
Interface Select the interface for this request object.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving your changes.
To Next Page
Loading...
