ZyXEL Communications ATP800 - Page 741

Chapter 37 System
ZyWALL ATP Series User’s Guide
741
Figure 506 Configuration > System > Notification
The following table describes the labels in this screen.
Table 326 Configuration > System > Notification
LABEL DESCRIPTION
Mail Server Type the name or IP address of the outgoing SMTP server.
Mail Subject Go to Configuration > Log & Report > Email Daily Report to type a subject line for outgoing
email from the Zyxel Device.
Append
system name
Select Append system name to add the Zyxel Device’s system name to the subject.
Append date
time
Select Append date time to add the Zyxel Device’s system date and time to the subject.
Mail Server Port Enter the same port number here as is on the mail server for mail traffic.
TLS Security Select this option if the mail server uses Transport Layer Security (TLS) for encrypted
communications between the mail server and the Zyxel Device.
STARTTLS Select this option if the mail server uses SSL or TLS for encrypted communications between the
mail server and the Zyxel Device.
Authenticate
Server
Select this if the Zyxel Device authenticates the mail server in the TLS handshake.
Mail From Type the email address from which the outgoing email is delivered. This address is used in
replies.
SMTP
Authentication
Select this check box if it is necessary to provide a user name and password to the SMTP server.
User Name This box is effective when you select the SMTP Authentication check box. Type the user name
to provide to the SMTP server when the log is emailed.
Password This box is effective when you select the SMTP Authentication check box. Type the password to
provide to the SMTP server when the log is emailed.
Retype to
Confirm
Type the password again to make sure that you have entered is correctly.
Time for sending
report
Select the time of day (hours and minutes) when the log is emailed. Use 24-hour notation.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.