Chapter 12 Wireless LAN
NBG5615 User’s Guide
112
See the rest of this chapter for information on the other labels in this screen.
12.3 Wireless Security
The screen varies depending on what you select in the Security Mode field.
12.3.1 No Security
Select No Security to allow wireless clients to communicate with the access points without any
data encryption.
Note: If you do not enable any wireless security on your NBG5615, your network is
accessible to any wireless networking device that is within range.
Figure 61 Network > Wireless LAN 2.4G/5G > General: No Security
Security Mode Select Static WEP, WPA-PSK, WPA, WPA2-PSK or WPA2 to add security on this
wireless network. The wireless clients which want to associate to this network must have
same wireless security settings as this device. After you select to use a security,
additional options appears in this screen. See Section 12.3 on page 112 for detailed
information on different security modes. Or you can select No Security to allow any
client to associate this network without authentication.
Note: If the WPS function is enabled (default), only No Security and WPA2-PSK are
available in this field.
Apply Click Apply to save your changes back to the NBG5615.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 37 Network > Wireless LAN 2.4G/5G > General (continued)
LABEL DESCRIPTION
To Next Page
Loading...
