NBG5615 User’s Guide 39
CHAPTER 4
Introducing the Web Configurator
4.1 Overview
This chapter describes how to access the NBG5615 Web Configurator and provides an overview of
its screens.
The Web Configurator is an HTML-based management interface that allows easy setup and
management of the NBG5615 via Internet browser. Use Internet Explorer 6.0 and later versions,
Mozilla Firefox 3 and later versions, or Safari 2.0 and later versions. The recommended screen
resolution is 1024 by 768 pixels.
In order to use the Web Configurator you need to allow:
• Web browser pop-up windows from your device. Web pop-up blocking is enabled by default in
Windows XP SP (Service Pack) 2.
• JavaScript (enabled by default).
• Java permissions (enabled by default).
Refer to the Troubleshooting chapter (Chapter 25 on page 203) to see how to make sure these
functions are allowed in Internet Explorer.
4.2 Accessing the Web Configurator
1 Make sure your NBG5615 hardware is properly connected and prepare your computer or computer
network to connect to the NBG5615 (refer to the Quick Start Guide).
2 Launch your web browser.
3 The NBG5615 is in router mode by default. Type "http://192.168.1.1" as the website address.
If the NBG5615 is in access point, the IP address is 192.168.1.2. See Chapter 5 on page 43 for
more information about the modes of the NBG5615.
Your computer must be in the same subnet in order to access this website address.
4.2.1 Login Screen
Note: If this is the first time you are accessing the Web Configurator, you may be
redirected to the Wizard. Refer to Chapter 3 on page 27 for the Connection Wizard
screens.
The Web Configurator initially displays the following login screen.
To Next Page
Loading...
