Chapter 2 ZyXEL NetUSB Share Center Utility
NBG5615 User’s Guide
24
2.2.2 The ZyXEL NetUSB Share Center Configuration Window
This section describes the utility’s configuration window, which allows you to set certain options for
the utility. These options do not apply to the USB devices connected to the NBG5615.
You can open it by clicking the Tools > Configuration menu command.
Figure 5 ZyXEL NetUSB Share Center Utility Configuration Window
Auto-Connect
Printer
Set Auto-Connect Printer You can set the selected printer to ‘auto-connect’
after you have connected it to your computer during
inital connection. If the printer is auto-connected to
your computer, they will always be connected over
the network. You do not need to configure it manually
each time.
Click this to show your installed printer list and select
the one you want to set as auto-connected.
Note: If the computer is connecting to the shared USB
printer for the first time, you need to click
Connect and setup the printer before you can
use the Auto-Connect Printer function. See
Chapter 9 on page 84 for more details.
Note: You first must install the appropriate drivers for
the printer that you intend to use.
Delete Auto-Connect Printer This removes the auto-connect option from the
selected printer.
Table 4 ZyXEL NetUSB Share Center Utility Main Screen Menus (continued)
MENU ITEM DESCRIPTION
To Next Page
Loading...
