Chapter 6 Easy Mode
NBG5615 User’s Guide
46
Figure 23 Easy Mode: Status Screen
6.2 What You Can Do
You can do the following in this mode:
•Use this Navigation Panel to opt out of the Easy mode (Section 6.4 on page 46).
•Use the Network Map screen to check if your NBG5615 can ping the gateway and whether it is
connected to the Internet (Section 6.5 on page 47).
•Use the Control Panel to configure and enable NBG5615 features, including wireless security,
wireless scheduling and bandwidth management and so on (Section 6.6 on page 48).
•Use the Status Screen to view read-only information about the NBG5615, including the WAN IP,
MAC address of the NBG5615 and the firmware version (Section 6.7 on page 54).
6.3 What You Need to Know
Between the different device modes, the Control Panel (Section 6.6 on page 48) changes
depending on which features are applicable to the mode:
• Router Mode: All Control Panel features are available.
• Access Point Mode: Only Power Saving and Wireless Security are available.
6.4 Navigation Panel
Use this navigation panel to opt out of the Easy mode.
Control Panel
Status Screen
Go to
Network
Map
Screen
Navigation Panel
To Next Page
Loading...
