Chapter 24 Maintenance
NBG5615 User’s Guide
194
The following table describes the labels in this screen.
24.4 Password Screen
It is strongly recommended that you change your NBG5615's password.
If you forget your NBG5615's password (or IP address), you will need to reset the device. See
Section 24.8 on page 199 for details.
Click Maintenance > Password. The screen appears as shown.
Figure 121 Maintenance > Password
The following table describes the labels in this screen.
Table 78 Maintenance > General
LABEL DESCRIPTION
System Name System Name is a unique name to identify the NBG5615 in an Ethernet network.
Domain Name Enter the domain name you want to give to the NBG5615.
Administrator
Inactivity Timer
Type how many minutes a management session can be left idle before the session times
out. The default is 5 minutes. After it times out you have to log in with your password
again. Very long idle timeouts may have security risks. A value of "0" means a
management session never times out, no matter how long it has been left idle (not
recommended).
Apply Click Apply to save your changes back to the NBG5615.
Cancel Click Cancel to begin configuring this screen afresh.
Table 79 Maintenance > Password
LABEL DESCRIPTION
Password Setup Change your NBG5615’s password (recommended) using the fields as shown.
Old Password Type the default password or the existing password you use to access the system in
this field.
New Password Type your new system password (up to 30 characters). Note that as you type a
password, the screen displays an asterisk (*) for each character you type.
Retype to Confirm Type the new password again in this field.
Apply Click Apply to save your changes back to the NBG5615.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
