ZyXEL Communications NBG5615 - NBG5615 Setup Tutorials; Setting Up a Wireless Network with WPS

NBG5615 User’s Guide 73
CHAPTER 9
Tutorials
9.1 Overview
This chapter provides tutorials for setting up your NBG5615.
• Set Up a Wireless Network with WPS
• Configure Wireless Security without WPS
• Using Multiple SSIDs on the NBG5615
• Automatically Connecting to a USB Printer
9.2 Set Up a Wireless Network with WPS
This section gives you an example of how to set up wireless network using WPS. This example uses
the NBG5615 as the AP and NWD210N as the wireless client which connects to a notebook.
Note: The wireless client must be a WPS-aware device (for example, a WPS USB adapter
or PCI card).
There are two WPS methods for creating a secure connection. This tutorial shows you how to do
both.
• Push Button Configuration (PBC) - create a secure wireless network simply by pressing a
button. See Section 9.2.1 on page 73.This is the easier method.
• PIN Configuration - create a secure wireless network simply by entering a wireless client's PIN
(Personal Identification Number) in the NBG5615’s interface. See Section 9.2.2 on page 74. This
is the more secure method, since one device can authenticate the other.
9.2.1 Push Button Configuration (PBC)
1 Make sure that your NBG5615 is turned on. Make sure the WIFI button (at the back panel of the
NBG5615) is pushed in, and that the device is placed within range of your notebook.
2 Make sure that you have installed the wireless client (this example uses the NWD210N) driver and
utility in your notebook.
3 In the wireless client utility, find the WPS settings. Enable WPS and press the WPS button (Start or
WPS button)
4 Log into NBG5615’s Web Configurator and press the Push Button in the Configuration >
Network > Wireless LAN 2.4G > WPS Station screen.