ZyXEL Communications NBG5615 - The Auto-Connect Printer List Window

Chapter 2 ZyXEL NetUSB Share Center Utility
NBG5615 User’s Guide
25
The following table describes the labels in this window.
2.2.3 The Auto-Connect Printer List Window
This section describes the utility’s auto-connect printer list window. You can open it by clicking the
Tools > Auto-Connect Printer List menu command.
Note: If the computer is connecting to the shared USB printer for the first time, you need
to click Connect and setup the printer before you can use the Auto-Connect
Printer function. See Chapter 9 on page 84 for more details.
Figure 6 ZyXEL NetUSB Share Center Utility Auto-Connect Printer List Window
The following table describes the labels in this screen.
Table 5 ZyXEL NetUSB Share Center Utility Configuration Window
LABEL DESCRIPTION
Basic Select this to run the utility automatically when you log into or start up Windows.
Language Select a language for the ZyXEL NetUSB Share Center Utility. You must restart the
utility for the change to take effect.
OK Click this to save your changes and close the window.
Cancel Click this cancel to close the window without saving.
Apply Click this to save your changes without closing the window.
Table 6 ZyXEL NetUSB Share Center Utility Auto-Connect Printer List Window
LABEL DESCRIPTION
Server IP & Printer
Name
Displays a list of print server IPs and printer names connected to this NBG5615.
Windows Printer Name Displays a corresponding list of Windows printer names connected to this devices
listed in the other list.
Delete Select an printer from the list and click this to remove it.
Close Click this to close the window.