Chapter 8 Access Point Mode
NBG5615 User’s Guide
69
8.4.1 Navigation Panel
Use the menu in the navigation panel to configure NBG5615 features in Access Point Mode.
Figure 42 Menu: Access Point Mode
Refer to Table 26 on page 61 for descriptions of the labels shown in the navigation panel.
8.5 LAN Screen
Use this section to configure your LAN settings while in Access Point Mode.
Click Network > LAN to see the screen below.
Note: If you change the IP address of the NBG5615 in the screen below, you will need to
log into the NBG5615 again using the new IP address.
Interface Status
Interface This displays the NBG5615 port types. The port types are: LAN and WLAN.
Status For the LAN ports, this field displays Down (line is down) or Up (line is up or connected).
For the 2.4GHz/5GHz WLAN, it displays Up when the 2.4GHz/5GHz WLAN is enabled or
Down when the 2.4G/5G WLAN is disabled.
Rate For the LAN ports, this displays the port speed and duplex setting or N/A when the line is
disconnected.
For the 2.4GHz/5GHz WLAN, it displays the maximum transmission rate when the 2.4GHz/
5GHz WLAN is enabled and N/A when the WLAN is disabled.
Table 27 Status Screen: Access Point Mode (continued)
LABEL DESCRIPTION
To Next Page
Loading...
