NBG5615 User’s Guide 151
CHAPTER 17
Static Route
17.1 Overview
This chapter shows you how to configure static routes for your NBG5615.
The NBG5615 usually uses the default gateway to route outbound traffic from computers on the
LAN to the Internet. To have the NBG5615 send data to devices not reachable through the default
gateway, use static routes.
For example, the next figure shows a computer (A) connected to the NBG5615’s LAN interface. The
NBG5615 routes most traffic from A to the Internet through the NBG5615’s default gateway (R1).
You create one static route to connect to services offered by your ISP behind router R2. You create
another static route to communicate with a separate network behind a router R3 connected to the
LAN.
Figure 90 Example of Static Routing Topology
17.2 IP Static Route Screen
Click Network > Static Route to open the Static Route screen.
To Next Page
Loading...
