Chapter 9 Tutorials
NBG5615 User’s Guide
76
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see Section 4.2 on page 39).
1 Make sure the WIFI switch (at the back panel of the NBG5615) is set to ON.
2 Open the Configuration > Network > Wireless LAN 2.4G > General screen in the AP’s Web
Configurator.
3 Confirm that the wireless LAN is enabled on the NBG5615.
4 Enter SSID_Example3 as the SSID and select Channel-06 as the channel. Set security mode to
WPA2-PSK and enter ThisismyWPA-PSKpre-sharedkey in the Pre-Shared Key field. Click
Apply.
To Next Page
Loading...
