ZyXEL Communications WAH7608 - 14.4 The Password Screen

Chapter 14 System
WAH7608 User’s Guide
114
Figure 71 System > Setting > Firmware Upgrade
14.4 The Password Screen
This screen allows you to change the WAH7608’s system password. It is strongly recommended that you
change your WAH7608's system password. To access this screen, click System > Setting > Password.
Figure 72 System > Setting > Password
The following table describes the labels in this screen.
14.5 The Session Timeout Screen
To access this screen, click System > Setting > Password > Session Timeout. Use this screen to configure
the length of inactive time before the WAH7608 automatically logs a user out of the web configurator.
Enter the time in the Session Timeout (Min) field, then click Apply to save your changes.
Table 36 System > Setting > Password
LABEL DESCRIPTION
Current Password Type the password you are currently using to log into the WAH7608 web configurator.
Password Type your new system password of between 4 and 24 characters. Note that as you type a
password, the screen displays as dot (.) for each character you type.
Reenter New
Password
Type the new password again in this field.
Apply Click Apply to save your changes back to the WAH7608.