Chapter 7 Monitor
WAH7608 User’s Guide
56
7.3 DHCP Table
DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows individual clients to obtain
TCP/IP configuration at start-up from a server. You can configure the WAH7608’s LAN as a DHCP server
or disable it. When configured as a server, the WAH7608 provides the TCP/IP configuration for the clients.
If DHCP service is disabled, you must have another DHCP server on that network, or else the device must
be manually configured.
Click Monitor > DHCP Table. Read-only information here relates to your DHCP status. The DHCP table
shows current DHCP client information (including MAC Address, and IP Address) of all network clients
using the WAH7608’s DHCP server.
Figure 19 Monitor > DHCP Table
The following table describes the labels in this screen.
Table 7 Monitor > DHCP Table
LABEL DESCRIPTION
# This is the index number of the host device.
Host Name This field displays the device host name.
IP Address This field displays the IP address relative to the # field listed above.
MAC Address This field shows the MAC address of the device with the name in the Host Name field.
Every Ethernet device has a unique MAC (Media Access Control) address which uniquely
identifies a device. The MAC address is assigned at the factory and consists of six pairs of
hexadecimal characters, for example, 00:A0:C5:00:00:02.
Reserve Select this if you want to reserve the IP address for this specific MAC address.
Cancel Click Cancel to reload the previous configuration for this screen.
Refresh Click Refresh to update this screen.
Apply Click Apply to save your changes back to the WAH7608.
To Next Page
Loading...
