ZyXEL Communications WAH7608 - OLED Screens

Chapter 1 Get to Know Your WAH7608
WAH7608 User’s Guide
13
Note: You must activate WPS on the WAH7608 and on another device within 2 minutes of
each other.
• Press the WPS button for more than 5 seconds: You can disable the WAH7608 WiFi network. No device
will be able to connect wirelessly to your WAH7608. Press for more than 5 seconds to reenable the WiFi
network.
1.8 OLED screens
This section describes the labels or icons displayed in the OLED screen of your WAH7608. When the
WAH7608 first turns on the following screen displays.
Figure 3 WAH7608 OLED Home screen
The following table describes the labels in this screen.
To change to the second screen, press the Power button twice. The following screen displays.
Table 1 WAH7608’s OLED Home screen
LABEL DESCRIPTION
This displays the type of network your WAH7608 is connected to and its signal
strength. Your network can be either 2G, 3G, or 4G.
It displays No Service if the SIM card does not have an active data plan or you
inserted the SIM card incorrectly and it could not be detected by the WAH7608.
It displays Pin Locked when the WAH7608 cannot access the SIM card because it is
locked.
This displays when the WAH7608 is receiving/transmitting data to/from the Internet.
This displays the
WiFi network status, The number indicates how many clients are
currently connected to the WAH7608.
This displays when the WAH7608 receives an SMS (Short Message Service) message.
This icon shows the WAH7608 battery life.
This shows your WAH7608’s Internet Service Provider.