Chapter 12 WiFi
WAH7608 User’s Guide
92
12.3 The WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your WAH7608.
WPS allows you to quickly set up a wireless network with strong security, without having to configure
security settings manually. Set up each WPS connection between two devices. Both devices must
support WPS. See Section 12.5.5.3 on page 101 for more information about WPS.
Note: To use the WPS feature, make sure you have wireless enabled in the Configuration >
WiFi > WPS screen.
Note: If you want to use the WPS feature set the security type to WPA or None.
Click Configuration > WiFi > WPS. The following screen displays.
Figure 54 Configuration > WiFi > WPS
Encryption Type Select None, or WPA Personal to add security on this wireless network. The wireless clients which
want to associate to this network must have same wireless security settings as the WAH7608.
When you select to use a security, additional options appear in this screen.
Or you can select None to allow any client to associate this network without any data
encryption or authentication.
WPA Mode This field appears when you select WPA Personal in the Encryption Type field.
Select Auto to allow wireless devices that support either WPA or WPA2 to connect to your
WAH7608’s wireless network.
Select WPA2 to allow only wireless devices that support WPA2 to connect to your WAH7608’s
wireless network.
Cipher Type Select the encryption type (AES, TKIP or TKIP and AES) for data encryption.
Select AES if your wireless clients can all use AES-CCMP.
Select TKIP if your wireless clients can all use TKIP.
Select TKIP and AES to allow the wireless clients to use either TKIP or AES.
Key Enter the key used for authentication the wireless clients must use to connect to the WAH7608.
Apply Click Apply to save your changes back to the WAH7608.
Table 27 Configuration > WiFi > Basic
LABEL DESCRIPTION
To Next Page
Loading...
