Chapter 8 Network
WAH7608 User’s Guide
64
The following table describes the labels in this screen.
8.3 The APN Setting Screen
Use this screen to view or configure a connection profile. A connection profile defines the parameters
that you need to connect to a mobile network, such as the APN, user name and password. Click
Configuration > Network > APN Configuration. The screen appears as shown next.
Figure 25 Configuration > Network > APN Configuration
Table 11 Configuration > Network > Connection
LABEL DESCRIPTION
Connection Operation
Connection Control This field displays the connected mode of the WAH7608. Select Auto Mode to
connect to the mobile network automatically if there is an available mobile
network. Otherwise, select Manual Mode. Click Change to apply your changes.
Roaming Mode Select Enable data roaming on the WAH7608. Otherwise, select Disable. Click
Change to apply your changes.
4G roaming is to use your mobile device in an area which is not covered by your
service provider. Enable roaming to ensure that your WAH7608 is kept connected to
the Internet when you are traveling outside the geographical coverage area of the
network to which you are registered.
Item This field always displays WAN Status.
PDN Type This displays the type PDN (Packet Data Network) of the connection profile.
State • This displays Connected when the connection profile has a connection with the
ISP.
• This displays Connecting when the connection profile is attempting a
connection with the ISP.
• This displays Disconnected when the connection profile is not connected to the
ISP.
• This displays Disconnecting when the connection profile is disconnecting from
the ISP.
Click Connect for the WAH7608 to attempt a connection with the ISP.
Cellular Profile This is the profile ID automatically by the WAH7608 to the connection profile.
To Next Page
Loading...
