ZyXEL Communications WAH7608 - 10.3 The IPv4;IPv6 Firewall Entries

Chapter 10 Firewall
WAH7608 User’s Guide
79
Figure 43 Configuration > Security > Firewall > Configure l
The following table describes the labels in this screen.
10.3 The IPv4/IPv6 Firewall Entries
The WAH7608 firewall is a packet filtering firewall and restricts access based on the source/destination
device network address of a packet and the type of application. Use this screen to configure IP filtering
rules. To access these screens, click Configuration > Firewall > IPv4 Firewall Entries or Configuration >
Firewall > IPv6 Firewall Entries.
Figure 44 Configuration > Security > Firewall > IPv4 Firewall Entries
Table 22 Configuration > Security > Firewall > Configure
LABEL DESCRIPTION
Firewall Enable Select this check box to activate the firewall. The WAH7608 performs access control and
protects against Denial of Service (DoS) attacks when the firewall is activated.
Packets Allowed Select Accept to allow access to the firewall rule in the list and block access to the ones that
don’t match.
Select Drop to block access to the firewall rule in the list and allow access to the ones that
don’t match.
Apply Click Apply to save the settings.