Chapter 3 The Web Configurator
WAH7608 User’s Guide
40
LTE Modem Status LTE Modem Status Use this screen to view information on your ISP, and your SIM status.
Configuration
Network Connection Use this screen to select the connection mode and activate roaming.
APN Setting Use this screen to configure user-defined connection profiles.
4G/3G/2G Modem Use this screen to select the type of network to which you want the
WAH7608 to connect.
PIN Use this screen to turn on or off PIN code authentication.
PLMN Use this screen to view available Public Land Mobile Networks (PLMNs)
and select a preferred network.
WiFi Client Use this screen to change your WAH7608 to client mode.
Data Usage Use this screen to specify limiting amount of package data.
LAN LAN Use this screen to view or configure the management IP address.
DHCP Use this screen to enable DHCP server.
File Sharing Use this screen to enable file sharing through the WAH7608.
Security Firewall Use this screen to enable the firewall.
NAT Use this screen to configure NAT type and configure port forwarding rules.
DMZ Use this screen to configure a default server.
WiFi Basic Use this screen to enable the wireless LAN, enter the SSID or select the
wireless security mode.
WPS Use this screen to activate WPS.
MAC Filter Use this screen to block or allow traffic from devices of certain MAC
addresses to the Device.
SMS New Message Use this screen to send messages using the WAH7608.
USSD Use this screen to send USSD (Unstructured Supplementary Service Data)
messages on the WAH7608.
Inbox Use this screen to view messages received on the WAH7608.
Outbox Use this screen to view messages sent from the WAH7608.
Draftbox Use this screen to view messages not yet sent from the WAH7608.
Settings SMS Use this screen to set the SMSC (Short Message Service Center) Address
and storage location.
System
About About Use this screen to view the device information.
Setting Firmware Upgrade Use this screen to upload new firmware to your WAH7608.
Password Use these screens to change your web configurator’s login password and
configure the inactive time before the WAH7608 logs out from the web
configurator.
Language Use this screen to change the web configurator’s language.
Date and Time Use this screen to change your WAH7608 time and date.
Power Saving Use this screen to configure the WAH7608 sleep mode and OLED display
timeout.
Reset Use this screen to reset the WAH7608 and return it to factory default
settings.
Reboot Use this screen to reboot the WAH7608 without turning the power off.
Table 5 Navigation Panel Summary
LINK TAB DESCRIPTION
To Next Page
Loading...
