Chapter 14 Bandwidth Control
XGS2210 Series User’s Guide
169
Figure 133 Advanced Application > Bandwidth Control (Stacking mode)
The following table describes the related labels in this screen.
Table 66 Advanced Application > Bandwidth Control
LABEL DESCRIPTION
Active Select this check box to enable bandwidth control on the Switch.
Slot (Stacking
mode)
This field appears only in stacking mode. Click the drop-down list to choose the slot number of the
Switch in a stack.
Port
(Standalone
or stacking
mode)
This field displays the port number. In stacking mode, the first number is the slot ID and the second
is the port number. * means all ports.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set the
common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to activate ingress rate limits on this port.
Ingress Rate Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the incoming traffic flow
on a port.
Note: Ingress rate bandwidth control applies to layer 2 traffic only.
Active Select this check box to activate egress rate limits on this port.
To Next Page
Loading...
