Chapter 14 Bandwidth Control
XGS2210 Series User’s Guide
170
Egress Rate Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the out-going traffic
flow on a port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields.
Table 66 Advanced Application > Bandwidth Control (continued)
LABEL DESCRIPTION
To Next Page
Loading...
