ZyXEL Communications XS1930-12F - Link Aggregation Control Protocol

Chapter 17 Link Aggregation
XS1930 Series User’s Guide
166
17.3.1 Link Aggregation Control Protocol
Click Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to display the screen
shown next. See Dynamic Link Aggregation on page 162 for more information on dynamic link
aggregation.
Figure 122 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
The following table describes the labels in this screen.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 75 Advanced Application > Link Aggregation > Link Aggregation Setting (continued)
LABEL DESCRIPTION
Table 76 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL DESCRIPTION
Link
Aggregation
Control
Protocol
Note: Do NOT configure this screen unless you want to enable dynamic link
aggregation.
Active Select this check box to enable Link Aggregation Control Protocol (LACP).