Chapter 4 Web Configurator
XS1930 Series User’s Guide
57
4.4.2 Protection
In Protection, you can set up loop guard and broadcast storm control.
In order to set up loop guard, please do the following. Click Wizard > Protection > Step 1 Loop Guard to
access this screen.
Figure 39 Wizard > Protection > Step 1 Loop Guard
Each field is described in the following table.
Type This field displays Static or LACP of this group.
Member This field displays the members of this group.
Previous Click Previous to show the previous screen.
Finish Review the information and click Finish to create the task.
Cancel Click Cancel to exit this screen without saving.
Table 13 Wizard > Basic > Step 4 Summary (continued)
LABEL DESCRIPTION
Table 14 Wizard > Protection > Step 1 Loop Guard
LABEL DESCRIPTION
Loop Guard
Select all ports Select all ports to enable the loop guard feature on all ports.
You can select a port by clicking it.
Next Click Next to show the next screen.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
