Chapter 8 Basic Setting
XS1930 Series User’s Guide
94
8.6.4 Network Proxy Configuration
The proxy server of an organization may prohibit communication between the Switch and NCC (Nebula
Control Center) (Section 8.11 on page 117). Use this screen to enable communication between the
Switch and NCC through the proxy server.
Figure 66 Network Proxy Configuration Application
As of this writing, this setting only allows communication between the Switch and the NCC.
Figure 67 Basic Setting > IP Setup > IP Configuration > Network Proxy Configuration
Cancel Click Cancel to reset the fields to your previous configuration.
Index This field displays the index number of an entry.
IP Address This field displays the IP address of the Switch in the IP domain.
IP Subnet Mask This field displays the subnet mask of the Switch in the IP domain.
VID This field displays the VLAN identification number of the IP domain on the Switch.
Type This field displays the type of IP address status.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Click Delete to remove the selected entry from the summary table.
Note: Deleting all IP subnets locks you out of the Switch.
Cancel Click Cancel to clear the check boxes.
Table 30 Basic Setting > IP Setup > IP Configuration (continued)
LABEL DESCRIPTION
To Next Page
Loading...
