ZyXEL Communications XS1930-12F - Chapter 3 Hardware Panels; Front Panel Connections; Hardware Panels

Chapter 3 Hardware Panels
XS1930 Series User’s Guide
33
CHAPTER 3
Hardware Panels
This chapter describes the front panel and rear panel of the Switch and shows you how to make the
hardware connections.
3.1 Front Panel Connections
The following figures show the front panels of the Switch.
Figure 10 Front Panel: XS1930-10
Figure 11 Front Panel: XS1930-12HP
Figure 12 Front Panel: XS1930-12F
The following table describes the ports.
Table 5 Front Panel Connections
CONNECTOR DESCRIPTION
100M, 1G, 2.5G, 5G,
and 10G RJ-45
Ethernet Ports
These are 10GBase-T auto-negotiating and auto-crossover Ethernet ports.
Connect these ports to a notebook computer, a gaming computer, a NAS (network-
attached storage), a server, a workstation, a WiFi 6 (802.11ax) router, a WiFi 6 (802.11ax) AP
(Access Point), or an Ethernet switch.
100M, 1G, 2.5G, 5G,
and 10G RJ-45 PoE
Ports
These are 10GBase-T auto-negotiating and auto-crossover Ethernet ports.
Connect these ports to a PTZ (pan, tilt and zoom) camera, a WiFi 6 (802.11ax) router, a WiFi 6
(802.11ax) AP, or an Ethernet switch.
1G, 10G SFP+ Slots Use SFP+ transceivers in these ports for high-bandwidth backbone connections. You can
also insert an SFP+ Direct Attach Copper (DAC) in the SFP+ slot.