EasyManua.ls Logo

ZyXEL Communications XS1930-12F - IGMP Snooping VLAN

ZyXEL Communications XS1930-12F
402 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 24 Multicast
XS1930 Series User’s Guide
202
24.3.2 IGMP Snooping VLAN
Click Advanced Application > Multicast > IPv4 Multicast in the navigation panel. Click the IGMP
Snooping link and then the IGMP Snooping VLAN link to display the screen as shown. See IGMP Snooping
and VLANs on page 198 for more information on IGMP Snooping VLAN.
Figure 145 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Snooping VLAN
The following table describes the labels in this screen.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 93 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping (continued)
LABEL DESCRIPTION
Table 94 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Snooping VLAN
LABEL DESCRIPTION
Mode Select auto to have the Switch learn multicast group membership information of any VLANs
automatically.
Select fixed to have the Switch only learn multicast group membership information of the
VLANs that you specify below.
In either auto or fixed mode, the Switch can learn up to 16 VLANs.
The Switch drops any IGMP control messages which do not belong to these 16 VLANs.
You must also enable IGMP snooping in the Multicast > IPv4 Multicast > IGMP Snooping screen
first.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
VLAN Use this section of the screen to add VLANs upon which the Switch is to perform IGMP
snooping.
Name Enter the descriptive name of the VLAN for identification purposes.
VID Enter the ID of a static VLAN; the valid range is between 1 and 4094.

Table of Contents

Related product manuals