Chapter 8 Basic Setting
XS1930 Series User’s Guide
99
8.8.1 PoE Time Range Setup
Use this screen to apply a schedule to the ports on the Switch. You must first configure a schedule in the
Advanced Application > Time Range screen.
Click the PoE Time Range Setup link in the Basic Setting > PoE Status screen. The following screen opens.
Figure 71 Basic Setting > PoE Setup > PoE Time Range Setup
The following table describes the labels in this screen.
Max Power (W) This field displays the maximum amount of power the PD could use from the Switch on this port.
Time-Range
State
This field shows whether or not the port currently receives power from the Switch according to its
schedule.
• It shows “In” followed by the time range name if PoE is currently enabled on the port.
• It shows “Out” if PoE is currently disabled on the port.
• It shows “–” if no schedule is applied to the port. PoE is enabled by default.
Table 33 Basic Setting > PoE Status (continued)
LABEL DESCRIPTION
Table 34 Basic Setting > PoE Setup > PoE Time Range Setup
LABEL DESCRIPTION
Port Enter the number of the port to which you want to apply a schedule.
Time Range This field displays the name of the schedule that you have created using the Advanced
Application > Time Range screen.
Select a pre-defined schedule to control when the Switch enables PoE to provide power on the
port. To select more than one schedule, press [SHIFT] and select the choices at the same time.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
To Next Page
Loading...
